[email protected]

mobile machines

4 Min Read
飞纯 Type 245 是基于 AS/NZS 1802:2003 卷筒与拖曳电缆 标准体系设计的矿用非常柔性长壁采煤机电缆，电压范围覆盖 1.1 至 6.6KV。根据产品资料，该电缆主要用作长壁采煤机电缆，也可用于连续采煤机和长壁外围电缆。 Type 245 的关键结构特征是 三根中央可伸长 Pilot / 控制芯线。这三根中央 Pilot 芯线可用于 接地连续性监测 和 控制回路。对于长壁采煤机来说，电缆不仅要传输动力电能，还要承担设备控制、保护联锁、接地连续性确认和移动工况下的安全监测任务。
Technical Department
on24/06/2026

什么是 NTSWOEU 0.6/1kV E-Loader Cable：Feichun 极高机械负载地下矿山移动设备电缆工程解析

NTSWOEU 0.6/1kV E-Loader Cable 是 Feichun 面向地下矿山移动机械、电动装载机、LHD、导向滑轮系统和卷盘供电系统开发的极高机械负载橡套电缆。资料明确指出，该电缆用于连接承受极高机械负载的移动机器，主要应用于矿山环境，也可通过导向滑轮运行，或作为 LHD 卷盘电缆使用，适用于极端弯曲负载、高拉伸应力、冲击负载和压扁负载。其核心结构由 Class 6 柔性镀锡铜导体、EPR 绝缘、GM1b 橡胶内护套、铜钢复合丝编织铠装兼同心接地导体，以及 5GM5 氯化橡胶外护套组成。
9 Min Read
LIFT-2S (European) vs. LIFT-1S UL (North American): LIFT-2S characteristics: Voltage: 300/500V (European standard, lower voltage) Temperature: −40°C to +70°C (moderate range) Standards: VDE 0482 part 265-2-1, EN 50265-2-1, IEC 60332-1-2 Design philosophy: Safety by material redundancy (2 steel cores) Steel cores: 2× cores provide mechanical backup Conductor: Class 6 (European, ~150–200 wires per mm²) Cost: Lower (proven European manufacturing) Market: Europe, Asia-Pacific, most of world LIFT-1S UL characteristics: Voltage: 600V (North American standard, higher voltage) Temperature: −25°C to +105°C (extreme range, high-temp optimized) Standards: UL 2562, UL 62, CSA C22.2 No.210.2 Design philosophy: Safety by certification (single core + redundant control) Steel core: 1× core (sufficient with nylon covering) Conductor: Class M (UL, extra fine ~300+ wires per mm²) Cost: Higher (UL testing, certification documentation) Market: North America (USA, Canada), Mexico UL 2562 specialty certification: UL 2562 scope: Elevator and Dumbwaiter Cables Specific requirements: 1. Pendant cable design (cable hangs freely, no duct support) 2. Vertical orientation (designed for gravity-loaded suspension) 3. Repeated flex cycles (cable moves up/down frequently) 4. Safety-critical function (failure = personnel risk) Consequence: More stringent than general-purpose cables Testing includes: Bend cycle fatigue, heat aging, compression resistance Test procedures (unique to UL 2562): Bend cycle test: 1,000+ cycles at minimum bending radius Cable must pass insulation resistance after cycling Heat aging: 500+ hours at 105°C continuous Tensile strength retention minimum 70% Compression: 1,000+ hours under sustained compression Cable cross-section must not exceed 5% permanent deformation LIFT-2S (no UL 2562): Tests per VDE are less stringent on fatigue/cycling Assumes cable mostly static, not repeated flex Adequate for European elevator duty (lower speed, fewer cycles) LIFT-1S UL: All UL 2562 tests passed (proven for North American elevators) Faster cycle times, more frequent motion → more fatigue stress Extra testing ensures reliability under North American elevator duty Market requirement (regulatory): Europe/International: CE mark required (European conformity) VDE/EN/IEC standards sufficient No UL certification needed (not recognized in EU) LIFT-2S is sufficient North America (USA, Canada): UL certification mandatory for elevators UL 2562 specifically for elevator cables CSA dual certification required in Canada LIFT-2S NOT acceptable (lacks UL 2562) LIFT-1S UL mandatory Cost implication: UL certification: ~$5,000–15,000 per product per region Testing duration: 3–6 months per model Documentation: Comprehensive test reports, technical files Result: LIFT-1S UL 20–30% higher cost than equivalent European cable
Technical Department
on16/06/2026

NSHCGEÖU KON+ST+ÜL для общего применения: тяжёлый кабель 0,6/1 kV для мобильных шахтных машин, контроля повреждений и вспомогательных цепей

NSHCGEÖU KON+ST+ÜL — это тяжёлый эластомерный кабель для подключения мобильных машин с очень высокой механической нагрузкой. По предоставленным данным он особенно применяется в шахтах для coal cutting and loading machines, а также для питания аппаратов, устройств и auxiliary electrical circuits. Конструкция объединяет три силовые жилы, двойные концентрические контрольные жилы, monitoring core, GM1b внутреннюю оболочку, гибкую броню из лужёных медных и оцинкованных стальных проволок, а также тяжёлую наружную оболочку 5GM5 жёлтого или красного цвета.