[email protected]

11kV feeder cable

4 Min Read
Geographic & Operational Context: Chuquicamata (Codelco) is transitioning from the world's largest open-pit copper mine to underground block caving (autonomous underground mining system). Depths: 700–1,500 meters below surface (Phase 1), expanding to 2,500+ meters (long-term). El Teniente (Codelco) is already operating at extreme depths: primary block caving at 2,000–2,500 m elevation below surface. Both mines employ: (1) Block caving gravity feed (fragmented ore flows down to cave level), (2) Mobile equipment (diesel-electric LHDs—Load-Haul-Dump vehicles, 30–50 ton capacity), (3) Fixed hoisting infrastructure (vertical shafts, incline decline haulage), (4) Extensive underground electrical distribution: 11 kV primary feeders, 6.6 kV secondaries, 3.3 kV distribution to mobile substations. 楚基卡马塔(国铜矿公司Codelco)正在从全球最大露天铜矿向地下自然崩落法(自主地下采矿系统)转型。深度：地表以下700-1,500米(第1阶段)，长期扩展至2,500+米。El Teniente(Codelco)已在极端深度运营：地表下2,000-2,500m主自然崩落区。两座矿山采用：(1)重力进给式自然崩落(碎矿由高处流下至崩落区)、(2)移动设备(柴油-电动LHD-装-运-卸车、30-50吨容量)、(3)固定提升基础设施(竖井、倾斜下降运输)、(4)广泛的地下电气配电：11 kV一级馈电、6.6 kV二级、3.3 kV配电至移动变电站。 Type 2S Selection Rationale: Underground fixed-installation feeders (in contrast to dragline/shovel trailing cables) experience: (1) Rock fall hazard (loose fragments falling from roof, occasional collapses), (2) Equipment impact (LHD vehicles occasionally strike cable trays during positioning), (3) Long service life (5–10+ years without planned removal), (4) Static or semi-static routing (no continuous reel cycling). Type 2S SWA (Steel Wire Armoured) is optimal because: (1) Mechanical armour (galvanized steel wire spiral) provides exceptional impact protection, (2) Symmetrical earth architecture supports high-impedance grounded distribution systems, (3) Heavy construction (11 ton/km total weight) means higher copper content → lower resistance → reduced voltage drop over long feeder runs.
Technical Department
on09/03/2026

AS/NZS 1972 Type 2S 11kV 3x185mm² SWA Armoured Feeder Cable for Chile Underground Copper Mines

Geographic & Operational Context: Chuquicamata (Codelco) is transitioning from the world’s largest open-pit copper mine to underground block caving (autonomous underground mining system). Depths: 700–1,500 meters below surface (Phase 1), expanding to 2,500+ meters (long-term). El Teniente (Codelco) is already operating at extreme depths: primary block caving at 2,000–2,500 m elevation below surface. Both mines employ: (1) Block caving gravity feed (fragmented ore flows down to cave level), (2) Mobile equipment (diesel-electric LHDs—Load-Haul-Dump vehicles, 30–50 ton capacity), (3) Fixed hoisting infrastructure (vertical shafts, incline decline haulage), (4) Extensive underground electrical distribution: 11 kV primary feeders, 6.6 kV secondaries, 3.3 kV distribution to mobile substations. 楚基卡马塔(国铜矿公司Codelco)正在从全球最大露天铜矿向地下自然崩落法(自主地下采矿系统)转型。深度：地表以下700-1,500米(第1阶段)，长期扩展至2,500+米。El Teniente(Codelco)已在极端深度运营：地表下2,000-2,500m主自然崩落区。两座矿山采用：(1)重力进给式自然崩落(碎矿由高处流下至崩落区)、(2)移动设备(柴油-电动LHD-装-运-卸车、30-50吨容量)、(3)固定提升基础设施(竖井、倾斜下降运输)、(4)广泛的地下电气配电：11 kV一级馈电、6.6 kV二级、3.3 kV配电至移动变电站。 Type 2S Selection Rationale: Underground fixed-installation feeders (in contrast to dragline/shovel trailing cables) experience: (1) Rock fall hazard (loose fragments falling from roof, occasional collapses), (2) Equipment impact (LHD vehicles occasionally strike cable trays during positioning), (3) Long service life (5–10+ years without planned removal), (4) Static or semi-static routing (no continuous reel cycling). Type 2S SWA (Steel Wire Armoured) is optimal because: (1) Mechanical armour (galvanized steel wire spiral) provides exceptional impact protection, (2) Symmetrical earth architecture supports high-impedance grounded distribution systems, (3) Heavy construction (11 ton/km total weight) means higher copper content → lower resistance → reduced voltage drop over long feeder runs.
13 Min Read
The nominal outer diameter (OD) of an AS/NZS 1972 Type 2S 11kV 3x185mm² feeder cable is 76.0 to 80.0 millimeters (3.0 to 3.15 inches). The typical design center for Feichun's Type 2S 3x185mm² product is approximately 78.6 mm. This measurement is taken across the outermost surface of the flame-retardant PVC sheath, which forms the final protective layer after the galvanized steel wire armour (SWA) and inner insulation geometry. 澳标 AS/NZS 1972 Type 2S 11kV 3x185mm² 馈电电缆的标称外径为 76.0 至 80.0 毫米（3.0 至 3.15 英寸）。 Feichun Type 2S 3x185mm² 产品的典型设计中心约为 78.6 mm。该测量是在钢丝铠装 (SWA) 和内层绝缘几何结构之后，在阻燃 PVC 外护套的最外表面进行的。 This 76–80 mm range is not arbitrary—it represents the accumulated thicknesses of multiple cable components layered concentrically around the three power conductors. To understand where this dimension comes from, an electrical engineer planning a mine installation must understand the contribution of each layer.
Technical Department
on06/03/2026

Outer Diameter Specs: What is the Nominal OD for AS/NZS 1972 Type 2S 11kV 3x185mm² Feeder Cable?

The nominal outer diameter (OD) of an AS/NZS 1972 Type 2S 11kV 3x185mm² feeder cable is 76.0 to 80.0 millimeters (3.0 to 3.15 inches). The typical design center for Feichun’s Type 2S 3x185mm² product is approximately 78.6 mm. This measurement is taken across the outermost surface of the flame-retardant PVC sheath, which forms the final protective layer after the galvanized steel wire armour (SWA) and inner insulation geometry. 澳标 AS/NZS 1972 Type 2S 11kV 3x185mm² 馈电电缆的标称外径为 76.0 至 80.0 毫米（3.0 至 3.15 英寸）。 Feichun Type 2S 3x185mm² 产品的典型设计中心约为 78.6 mm。该测量是在钢丝铠装 (SWA) 和内层绝缘几何结构之后，在阻燃 PVC 外护套的最外表面进行的。 This 76–80 mm range is not arbitrary—it represents the accumulated thicknesses of multiple cable components layered concentrically around the three power conductors. To understand where this dimension comes from, an electrical engineer planning a mine installation must understand the contribution of each layer.
10 Min Read
The Single Most Important Cable Design Decision in Underground Coal Mining: Whether the cable employs collective screening (Type 2) or individual phase screening (Type 2S). This single engineering choice directly determines whether a mechanical cable failure will result in a phase-to-earth fault (detected and stopped in milliseconds) or a phase-to-phase fault with thousands of amperes of arc current (igniting methane explosions).
Technical Department
on06/03/2026

Type 2 vs Type 2S: Why the “S” (Individual Screen) is Mandatory for 11kV Underground Coal Mines

The Single Most Important Cable Design Decision in Underground Coal Mining: Whether the cable employs collective screening (Type 2) or individual phase screening (Type 2S). This single engineering choice directly determines whether a mechanical cable failure will result in a phase-to-earth fault (detected and stopped in milliseconds) or a phase-to-phase fault with thousands of amperes of arc current (igniting methane explosions).