[email protected]

电抗

2 Min Read
AS/NZS 1802 电缆型号
Technical Department
on22/06/2026

AS/NZS 1802/2802 矿用卷筒/拖曳电缆选型计算器：载流量、电压降、短路热稳定一页算清

面向电气工程师的 AS/NZS 1802/2802 电缆工具箱：从负载电流、卷筒降额到功率因数补偿和年损耗，快速形成选型依据
7 Min Read
UNE 22512 — formally titled "Cables flexibles para minería subterránea con tensiones de 1,8/3 kV y 0,6/1 kV con aislamiento de caucho, con armadura" (Flexible cables for underground mining, rubber-insulated, armoured) — exists as a parallel but fundamentally distinct standard from its unarmoured sibling UNE 22511. Where UNE 22511 is engineered as a torsion-optimized drag cable for mobile equipment, UNE 22512 is engineered as a crush-and-cut protected feeder cable for semi-fixed installations where mechanical damage from external forces (falling rock, equipment impact, floor pressure) is a documented operational risk, but the extreme torsional loading of continuously moving equipment is not. The addition of metallic armour — specifically, galvanized steel wire braid forming what the standard designates as M2 GSWB — is the defining structural choice that reshapes every downstream design decision in the cable. The armour is not merely a protective layer added to an otherwise standard cable; rather, it fundamentally alters the cable's mechanical behavior, installation requirements, cost structure, and applicable fatigue loading regimes. Understanding UNE 22512 therefore requires understanding not just what the armour is, but why its presence necessitates a completely different engineering philosophy compared to unarmoured cables. The standard was developed by AENOR (Asociación Española de Normalización y Certificación) to address a specific operational problem encountered in Spanish and Latin American underground mining installations. While drag cables experience cyclic torsional loading as the controlling mechanical stress, semi-fixed installation cables experience something categorically different: static or low-cycle crushing and cutting stresses from external impacts, combined with continuous exposure to abrasive underground surfaces and sharp rock edges. A cable optimized exclusively for torsional fatigue — such as UNE 22511 — when installed in a semi-fixed route subject to crushing and cutting, experiences mechanical failure not through fatigue mechanisms but through acute sheath penetration, insulation damage, and moisture ingress. Conversely, an armoured cable optimized for crush protection, if inappropriately installed in a drag duty application, fails not through crushing (which the armour prevents) but through torsional fatigue of the armour wires themselves — a more insidious failure mode that occurs entirely within the armour structure, invisible until complete armour failure exposes the underlying insulation.
Technical Department
on15/06/2026

卷筒电缆技术手册操作安装与电气

本手册中的弯曲半径、载流量、降容系数、压降与短路数据,依据 DIN VDE 0298-4、VDE 0250、IEC 等公开标准的通用工程值,适用于一般卷筒/移动电缆的技术说明与方案初选。具体工程须按项目实际工况核算;飞纯具体产品的型号、外径、重量、电缆盘规格等参数,以飞纯正式产品规格书与实测数据为准。安装应由专业人员执行,并参照适用标准与现场条件。