[email protected]

bulk terminal cable

4 Min Read
Geographic & Operational Context: Chuquicamata (Codelco) is transitioning from the world's largest open-pit copper mine to underground block caving (autonomous underground mining system). Depths: 700–1,500 meters below surface (Phase 1), expanding to 2,500+ meters (long-term). El Teniente (Codelco) is already operating at extreme depths: primary block caving at 2,000–2,500 m elevation below surface. Both mines employ: (1) Block caving gravity feed (fragmented ore flows down to cave level), (2) Mobile equipment (diesel-electric LHDs—Load-Haul-Dump vehicles, 30–50 ton capacity), (3) Fixed hoisting infrastructure (vertical shafts, incline decline haulage), (4) Extensive underground electrical distribution: 11 kV primary feeders, 6.6 kV secondaries, 3.3 kV distribution to mobile substations. 楚基卡马塔(国铜矿公司Codelco)正在从全球最大露天铜矿向地下自然崩落法(自主地下采矿系统)转型。深度：地表以下700-1,500米(第1阶段)，长期扩展至2,500+米。El Teniente(Codelco)已在极端深度运营：地表下2,000-2,500m主自然崩落区。两座矿山采用：(1)重力进给式自然崩落(碎矿由高处流下至崩落区)、(2)移动设备(柴油-电动LHD-装-运-卸车、30-50吨容量)、(3)固定提升基础设施(竖井、倾斜下降运输)、(4)广泛的地下电气配电：11 kV一级馈电、6.6 kV二级、3.3 kV配电至移动变电站。 Type 2S Selection Rationale: Underground fixed-installation feeders (in contrast to dragline/shovel trailing cables) experience: (1) Rock fall hazard (loose fragments falling from roof, occasional collapses), (2) Equipment impact (LHD vehicles occasionally strike cable trays during positioning), (3) Long service life (5–10+ years without planned removal), (4) Static or semi-static routing (no continuous reel cycling). Type 2S SWA (Steel Wire Armoured) is optimal because: (1) Mechanical armour (galvanized steel wire spiral) provides exceptional impact protection, (2) Symmetrical earth architecture supports high-impedance grounded distribution systems, (3) Heavy construction (11 ton/km total weight) means higher copper content → lower resistance → reduced voltage drop over long feeder runs.
Technical Department
on09/03/2026

AS/NZS 1972 Type 2S 11kV 3x185mm² SWA Armoured Feeder Cable for Chile Underground Copper Mines

Geographic & Operational Context: Chuquicamata (Codelco) is transitioning from the world’s largest open-pit copper mine to underground block caving (autonomous underground mining system). Depths: 700–1,500 meters below surface (Phase 1), expanding to 2,500+ meters (long-term). El Teniente (Codelco) is already operating at extreme depths: primary block caving at 2,000–2,500 m elevation below surface. Both mines employ: (1) Block caving gravity feed (fragmented ore flows down to cave level), (2) Mobile equipment (diesel-electric LHDs—Load-Haul-Dump vehicles, 30–50 ton capacity), (3) Fixed hoisting infrastructure (vertical shafts, incline decline haulage), (4) Extensive underground electrical distribution: 11 kV primary feeders, 6.6 kV secondaries, 3.3 kV distribution to mobile substations. 楚基卡马塔(国铜矿公司Codelco)正在从全球最大露天铜矿向地下自然崩落法(自主地下采矿系统)转型。深度：地表以下700-1,500米(第1阶段)，长期扩展至2,500+米。El Teniente(Codelco)已在极端深度运营：地表下2,000-2,500m主自然崩落区。两座矿山采用：(1)重力进给式自然崩落(碎矿由高处流下至崩落区)、(2)移动设备(柴油-电动LHD-装-运-卸车、30-50吨容量)、(3)固定提升基础设施(竖井、倾斜下降运输)、(4)广泛的地下电气配电：11 kV一级馈电、6.6 kV二级、3.3 kV配电至移动变电站。 Type 2S Selection Rationale: Underground fixed-installation feeders (in contrast to dragline/shovel trailing cables) experience: (1) Rock fall hazard (loose fragments falling from roof, occasional collapses), (2) Equipment impact (LHD vehicles occasionally strike cable trays during positioning), (3) Long service life (5–10+ years without planned removal), (4) Static or semi-static routing (no continuous reel cycling). Type 2S SWA (Steel Wire Armoured) is optimal because: (1) Mechanical armour (galvanized steel wire spiral) provides exceptional impact protection, (2) Symmetrical earth architecture supports high-impedance grounded distribution systems, (3) Heavy construction (11 ton/km total weight) means higher copper content → lower resistance → reduced voltage drop over long feeder runs.
21 Min Read
If you are an electrical engineer reviewing a Bill of Materials for a Kalimantan mining project and the BOM line reads "AS/NZS 1972 Type 2S 6.6kV 3×185mm² Armoured Cable," the cable you actually need is an AS/NZS 1972 Mine Feeder Cable rated 6.35/11kV, with 3×185mm² copper conductors, XLPE or EPR insulation, copper tape screen, and galvanised steel wire armour (SWA). The "Type 2S" designation on your BOM is technically incorrect for this voltage class—a point we will clarify in detail below—but the intent behind the specification is clear: a heavy-duty, armoured, medium-voltage power cable for primary distribution in an underground or open-pit mine. 如果您是一名审查加里曼丹矿区物料清单（BOM）的电气工程师，BOM 上写着"AS/NZS 1972 Type 2S 6.6kV 3×185mm² 铠装电缆"，您实际需要的是 AS/NZS 1972 矿用馈线电缆，额定 6.35/11kV，3×185mm² 铜导体，XLPE 或 EPR 绝缘，铜带屏蔽，镀锌钢丝铠装（SWA）。BOM 上的"Type 2S"标识在此电压等级下技术上不正确——我们将在下文详细说明——但规格的意图是明确的：用于矿井主干配电的重型铠装中压电力电缆。 The ampacity you should design around at 40°C ambient air temperature in Kalimantan is approximately 420 amperes for cable tray or free-air installation, and approximately 370 amperes for direct burial in tropical soil at 30°C ground temperature. These figures are derated from the standard 30°C base-case ampacity of approximately 460 A (air) and the 20°C base-case of approximately 400 A (ground), using the thermal derating methodology prescribed in AS/NZS 3008.1.1 and IEC 60502-2. The full derivation, including the governing equations and correction factors for Kalimantan's specific environmental conditions, follows in Sections 6 and 7.
Technical Department
on09/03/2026

AS/NZS 1972 Mine Feeder Cable 6.35/11kV 3×185mm² SWA: Ampacity Derating at 40°C for Kalimantan Coal and Nickel Mines

If you are an electrical engineer reviewing a Bill of Materials for a Kalimantan mining project and the BOM line reads “AS/NZS 1972 Type 2S 6.6kV 3×185mm² Armoured Cable,” the cable you actually need is an AS/NZS 1972 Mine Feeder Cable rated 6.35/11kV, with 3×185mm² copper conductors, XLPE or EPR insulation, copper tape screen, and galvanised steel wire armour (SWA). The “Type 2S” designation on your BOM is technically incorrect for this voltage class—a point we will clarify in detail below—but the intent behind the specification is clear: a heavy-duty, armoured, medium-voltage power cable for primary distribution in an underground or open-pit mine. 如果您是一名审查加里曼丹矿区物料清单（BOM）的电气工程师，BOM 上写着”AS/NZS 1972 Type 2S 6.6kV 3×185mm² 铠装电缆”，您实际需要的是 AS/NZS 1972 矿用馈线电缆，额定 6.35/11kV，3×185mm² 铜导体，XLPE 或 EPR 绝缘，铜带屏蔽，镀锌钢丝铠装（SWA）。BOM 上的”Type 2S”标识在此电压等级下技术上不正确——我们将在下文详细说明——但规格的意图是明确的：用于矿井主干配电的重型铠装中压电力电缆。 The ampacity you should design around at 40°C ambient air temperature in Kalimantan is approximately 420 amperes for cable tray or free-air installation, and approximately 370 amperes for direct burial in tropical soil at 30°C ground temperature. These figures are derated from the standard 30°C base-case ampacity of approximately 460 A (air) and the 20°C base-case of approximately 400 A (ground), using the thermal derating methodology prescribed in AS/NZS 3008.1.1 and IEC 60502-2. The full derivation, including the governing equations and correction factors for Kalimantan’s specific environmental conditions, follows in Sections 6 and 7.