[email protected]

250°C

7 Min Read
FLEXIDRUM® MEDIUM RS (N)TSCGEWÖU：高柔性盐雾防护港口电缆 专业级高柔性盐雾防护电源电缆，专为恶劣海洋环境设计。采用最小12×D鼓面弯曲半径、超强盐雾腐蚀防护、UV/臭氧/湿度防护，跨越3.6/6kV至12/20kV完整电压平台。专用于挖泥船、海洋泵站和港口设备，15年+服役期验证。 港口电缆技术革新：恶劣海洋环境的专业防腐蚀工程 传统电源电缆部署在盐雾海洋环境中会遭遇加速退化机制：卤化物诱导的铜导体电化学腐蚀、渗透水通过外护套微裂纹、光化学紫外线降解聚合物基质、臭氧氧化聚合物交链脆化。标准FLEXIDRUM®电缆（非专化聚合物护套）在持续港口运行的7-10年内经历~35-50%的机械抗张强度损失，导致提前更换周期和港口设备运行中的意外维护中断。 FLEXIDRUM® MEDIUM RS (N)TSCGEWÖU代表材料化学和护套架构的突破性进展，整合：(1)专化PCP外护套化合物，具有专有防盐雾化学物质（氯化钠渗透防护比标准PCP配方高2倍，符合IEC测试规程），(2)先进多层半导电屏障界面，具有疏水分子结构，防止锡铜导体上的电化学腐蚀途径，(3)集成UV/臭氧吸收添加剂，在15年以上服务周期内减少聚合物链断裂退化约60%，(4)优化柔性架构，支持12×D鼓面部署半径（相比常规专化电缆的15×D及更高），对需要跨地理分布港口设施频繁再部署的移动挖泥设备至关重要。
Technical Department
on16/06/2026

NTSWÖU-J Trailing Cable: тяжёлый кабель 0,6/1 kV для шахт, тоннелей, кранов и trolley systems

NTSWÖU-J — это trailing cable для сухих, влажных и мокрых мест, где присутствуют механические воздействия. По предоставленным данным он применяется в шахтах, trolley systems, кранах и тоннельных применениях как кабель питания. Конструкция включает лужёные медные жилы DIN VDE 0295 Class 5, изоляцию 3GI3, межжильные заземляющие жилы, внутреннюю оболочку GM1b и тяжёлую наружную оболочку 5GM5 жёлтого или чёрного цвета.
4 Min Read
What Are UNE 22560 and UNE 22561? Scope, Definitions, and Core Purpose The UNE 22560 and UNE 22561 standards represent the final and often most underestimated element of the Spanish and Latin American underground mining cable ecosystem. Where UNE 22511 and UNE 22512 govern the power distribution cables that energize mining equipment, the 22560 and 22561 standards govern the signal, control, and interlock cables that command and protect that equipment. These are the "nervous system" cables of a mine — the communication network that tells a continuous miner when to advance and when to halt, that triggers emergency stops, that monitors hoisting rope tension on shaft equipment, that controls conveyor sequencing, and that enables the protective interlocking that prevents a piece of equipment from operating unless all safety preconditions are met. UNE 22560 formally defines flexible multi-core cables for underground mining with voltage ratings up to 500 V or 0.6/1 kV, with no metallic armour protection — designed for installation within equipment enclosures, along protected cable trays in main gate roads, or in areas where mechanical damage risk is minimal. UNE 22561 is its armoured sister standard, incorporating steel wire braid or steel tape protection, specified for installation in rough terrain areas where mechanical damage from rock fall, equipment collision, or floor contact is a credible risk. Both standards mandate that the cable be designed as a multi-core concentric stranded bundle — not the parallel-laid three or four conductors common in power cables, but rather seven, twelve, nineteen, or more individually insulated cores twisted concentrically around a central axis, allowing compact packaging of numerous independent control circuits within a single cable jacket. The distinction between these standards is not merely mechanical armour presence or absence. Control cables are tested against an entirely different set of safety criteria than power cables because their failure mode is fundamentally different. A power cable failure results in loss of energy to equipment — dangerous but localized. A control cable failure can disable the interlock system that prevents a continuous miner from advancing into unsafe ground, or can disable the emergency stop circuit that should halt a conveyor if a worker falls into it. A control cable fire, burning in a tightly bundled cable tray with other control cables, must not spread flame between cables because control cables are typically routed in shared ducts and cable carriers where one cable's ignition could cascade to adjacent circuits. Therefore, control cables are tested for bundle flame propagation (EN 60332-3) rather than single-cable flame propagation tests — a more stringent requirement that demands careful attention to outer sheath formulation and cable spacing in bundle installation.
Technical Department
on11/06/2026

TDS КГРТЭ-ХЛ：0.66/1 kV 变频驱动用屏蔽柔性矿用电缆

TDS КГРТЭ-ХЛ 是一种额定电压 0.66/1 kV、最大工作电压 0.69/1.2 kV、频率最高 400 Hz 的橡胶绝缘、橡胶护套、总屏蔽柔性动力电缆，执行 ТУ 16.К73.168-2017。该电缆用于带频率调节的电驱动系统，为移动和固定对象、机器、机构及其他设备供电，包括矿山钻机等设备
4 Min Read
C PUR Design Integration: FLEXIFESTOON PUR characteristics (inherited): Outer sheath: PUR (polyurethane, compact) Insulation: Special TPE (superior elongation) Central unit: Textile (mechanical support) Weight: 25–30% lighter than standard rubber Diameter: 15–20% smaller than rubber equivalent Cost: +15–25% premium over rubber Service life: 10–15 years (extended) Screened design addition (new): Screen: Tinned copper braid (EMC shielding) Coverage: 80–90% (good EMC performance) Diameter impact: +2–3 mm (screen adds ~3 mm to diameter) Weight impact: +500 kg/km (braid + outer sheath) Cost: Additional +10–15% for screen layer Combined C PUR result: vs. Unscreened PUR (FLEXIFESTOON PUR): FLEXIFESTOON PUR: Minimal diameter/weight, no EMC C PUR: Slightly larger (screen added), excellent EMC Choice: PUR for maximum compactness (non-EMI environments) C PUR for VFD motors, confined spaces with EMC requirements vs. Standard rubber screened (GRDGCGÖU-J): GRDGCGÖU-J: Standard diameter, heavy, rubber durability C PUR: Compact diameter, lightweight, superior oil/chemical resistance Choice: GRDGCGÖU-J for simple temporary festoon C PUR for permanent industrial machine tool installation Nomenclature: FLEXIFESTOON® = Product family (flexible cable) C = Screen (copper braid, "C" from German "Schirm") PUR = Material (polyurethane jacket) Result: "FLEXIFESTOON C PUR" = Screened compact polyurethane cable
Technical Department
on11/06/2026

什么是 HoldMine КРЭ 10 kV：矿井电网提高电气安全性铠装动力电缆

КРЭБбШпнг(А)-HF、КРЭКШпнг(А)-HF、КРЭКбШпнг(А)-HF、КРЭБбШв、КРЭКШв、КРЭКбШв 是额定交流电压 10 kV 的提高电气安全性动力电缆。它们用于矿井电气网络中电能的传输和分配，可沿矿井水平巷道、倾斜巷道以及垂直钻孔敷设，额定频率为 50 Hz