[email protected]

无拉伸载荷

10 Min Read
LIFT-2S (European) vs. LIFT-1S UL (North American): LIFT-2S characteristics: Voltage: 300/500V (European standard, lower voltage) Temperature: −40°C to +70°C (moderate range) Standards: VDE 0482 part 265-2-1, EN 50265-2-1, IEC 60332-1-2 Design philosophy: Safety by material redundancy (2 steel cores) Steel cores: 2× cores provide mechanical backup Conductor: Class 6 (European, ~150–200 wires per mm²) Cost: Lower (proven European manufacturing) Market: Europe, Asia-Pacific, most of world LIFT-1S UL characteristics: Voltage: 600V (North American standard, higher voltage) Temperature: −25°C to +105°C (extreme range, high-temp optimized) Standards: UL 2562, UL 62, CSA C22.2 No.210.2 Design philosophy: Safety by certification (single core + redundant control) Steel core: 1× core (sufficient with nylon covering) Conductor: Class M (UL, extra fine ~300+ wires per mm²) Cost: Higher (UL testing, certification documentation) Market: North America (USA, Canada), Mexico UL 2562 specialty certification: UL 2562 scope: Elevator and Dumbwaiter Cables Specific requirements: 1. Pendant cable design (cable hangs freely, no duct support) 2. Vertical orientation (designed for gravity-loaded suspension) 3. Repeated flex cycles (cable moves up/down frequently) 4. Safety-critical function (failure = personnel risk) Consequence: More stringent than general-purpose cables Testing includes: Bend cycle fatigue, heat aging, compression resistance Test procedures (unique to UL 2562): Bend cycle test: 1,000+ cycles at minimum bending radius Cable must pass insulation resistance after cycling Heat aging: 500+ hours at 105°C continuous Tensile strength retention minimum 70% Compression: 1,000+ hours under sustained compression Cable cross-section must not exceed 5% permanent deformation LIFT-2S (no UL 2562): Tests per VDE are less stringent on fatigue/cycling Assumes cable mostly static, not repeated flex Adequate for European elevator duty (lower speed, fewer cycles) LIFT-1S UL: All UL 2562 tests passed (proven for North American elevators) Faster cycle times, more frequent motion → more fatigue stress Extra testing ensures reliability under North American elevator duty Market requirement (regulatory): Europe/International: CE mark required (European conformity) VDE/EN/IEC standards sufficient No UL certification needed (not recognized in EU) LIFT-2S is sufficient North America (USA, Canada): UL certification mandatory for elevators UL 2562 specifically for elevator cables CSA dual certification required in Canada LIFT-2S NOT acceptable (lacks UL 2562) LIFT-1S UL mandatory Cost implication: UL certification: ~$5,000–15,000 per product per region Testing duration: 3–6 months per model Documentation: Comprehensive test reports, technical files Result: LIFT-1S UL 20–30% higher cost than equivalent European cable
Technical Department
on11/06/2026

Что такое ÖLFLEX® 100 I: инженерный анализ ISI-маркированного ПВХ-кабеля до 1100 V

ÖLFLEX® 100 I — это ISI-маркированный ПВХ-кабель для plant engineering, installation, industrial machinery, air-conditioning power circuits, main power circuits to individual apartments and dry or damp interiors under medium mechanical load conditions. По предоставленным данным кабель построен на тонкопроволочных голых медных жилах class 5 по IS 8130-1984, имеет ПВХ-изоляцию, наружную оболочку PVC или PVC FR-LSH по IS 694:2010, номинальное напряжение до 1100 V и повышенную электрическую прочность за счёт испытательного напряжения 3 kV.
11 Min Read
FLEXIFESTOON® SEOOW YELLOW represents FeiChun's entry into the low-voltage festoon and temporary power market. The nomenclature requires careful explanation to distinguish this product from the high-voltage FLEXIDRUM series: FLEXIFESTOON Product Nomenclature: FLEXIFESTOON® = Product family name Flex = Flexible (emphasis on bending & handling) Festoon = Strung overhead in continuous runs (typical festoon lighting application) SEOOW = Industry-standard designation S = Service cord (temporary, not permanent installation) E = Elastomer jacket (flexible sheath) OO = Oil-resistant conductor insulation (TPE qualifies as oil-resistant) W = Weather-resistant sheath (water, ozone, UV resistant) SEOOW is defined in: UL 62 (Standard for Flexible Cords and Cables) CSA 22.2 No. 49 (Canadian equivalent) NFPA 70 National Electrical Code (NEC) Article 400 YELLOW designation: Color: RAL 1021 (traffic yellow, high visibility) Safety significance: Yellow cords attract attention in job sites Practical purpose: Easy to identify, prevent trips/entanglement Contrast with FLEXIDRUM series: FLEXIDRUM (High-Voltage MV Cable): Voltage: 3.6 kV to 20/35 kV (power distribution) Temperature: −40 to +80°C (standard industrial) Application: Mobile mining/tunneling equipment (capital-intensive) Size: Large diameter, heavy (3–12 kg/km) FLEXIFESTOON (Low-Voltage Service Cord): Voltage: 600V (light/power temporary use) Temperature: −60 to +105°C (extreme environmental range) Application: Festoon lighting, temporary site power, outdoor events Size: Small diameter, lightweight (0.05–0.3 kg/m) Cost: Consumer/contractor-grade (not specialty industrial)
Technical Department
on11/06/2026

Что такое ÖLFLEX® 191K: инженерный анализ гибкого многожильного AWM-кабеля UL STYLE AWM 21098

ÖLFLEX® 191K — это гибкий многожильный AWM-кабель с UL STYLE AWM 21098 и cRU AWM I/II A/B FT1, предназначенный для plant engineering, industrial machinery, air-conditioning systems и других сред, где применяются общие многожильные AWM-кабели. Его конструкция основана на тонкопроволочных медных жилах класса 5, ПВХ-изоляции и ПВХ-наружной оболочке серого или чёрного цвета. Кабель рассчитан на AC 600 V, испытательное напряжение AC 2000 V и температурный диапазон до +90°C.
13 Min Read
EMC Performance Classification: EMC rating scale (VDE/EN standards): Basic: No shielding (part 813 unscreened) Fair: Partial coverage, 30–40 mm spacing in braid Good: 80–90% coverage, 95% coverage, all gaps 30 dB attenuation @ 500 kHz: >40 dB attenuation @ 5 MHz: >35 dB attenuation (typical peak range) Expected: Tinned copper braid achieves 35–50 dB across frequency range Immunity to external interference: Motor variable frequency drive (VFD) nearby: VFD RF emission: Typically 50–200 mV/m at cable distance Unshielded cable susceptibility: 100–500 mV induced noise Shielded cable (good EMC): 1–10 mV induced noise (50–100× reduction) Consequence: VFD-driven crane motor doesn't interfere with control signals No false triggering of safety systems Data integrity in digital control systems maintained Radiated immunity testing (per EN 61000-4-3): Test standard: Cable exposed to RF field 50 MHz–1 GHz Test field strength: 10 V/m typical Acceptance: No malfunction, signal corruption
Technical Department
on11/06/2026

Что такое ÖLFLEX® 191K CY: экранированный гибкий многожильный AWM approval cable — инженерный анализ для шкафов управления, промышленного оборудования и тяжёлых машин

ÖLFLEX® 191K CY — это экранированный гибкий многожильный кабель с AWM approval, рассчитанный на AC 600 V, испытательное напряжение AC 4000 V, широкий температурный диапазон до +90°C, тонкопроволочные медные жилы по VDE 0295 class 5 / IEC 60228 class 5, PVC insulation, PVC inner sheath, tinned-copper braiding и PVC outer sheath grey or black. Его основная инженерная область — control cabinets, plant engineering, industrial machinery, air-conditioning systems и EMC-sensitive environments, где требуется монтажная гибкость, высокий уровень экранирования и надёжная работа в условиях общей механической прочности. Для портовых кранов, горнодобывающей техники и тяжёлых подвижных машин Feichun рассматривает такую конструкцию как полезную базу, но дополняет её анализом растягивающих нагрузок, абразивного износа, динамического изгиба, вибрации и фактической кабельной трассы.